You cannot select more than 25 topics
Topics must start with a letter or number, can include dashes ('-') and can be up to 35 characters long.
271 lines
7.6 KiB
C
271 lines
7.6 KiB
C
/**
|
|
* \file
|
|
*
|
|
* \brief SAM USB HPL
|
|
*
|
|
* Copyright (c) 2015-2018 Microchip Technology Inc. and its subsidiaries.
|
|
*
|
|
* \asf_license_start
|
|
*
|
|
* \page License
|
|
*
|
|
* Subject to your compliance with these terms, you may use Microchip
|
|
* software and any derivatives exclusively with Microchip products.
|
|
* It is your responsibility to comply with third party license terms applicable
|
|
* to your use of third party software (including open source software) that
|
|
* may accompany Microchip software.
|
|
*
|
|
* THIS SOFTWARE IS SUPPLIED BY MICROCHIP "AS IS". NO WARRANTIES,
|
|
* WHETHER EXPRESS, IMPLIED OR STATUTORY, APPLY TO THIS SOFTWARE,
|
|
* INCLUDING ANY IMPLIED WARRANTIES OF NON-INFRINGEMENT, MERCHANTABILITY,
|
|
* AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT WILL MICROCHIP BE
|
|
* LIABLE FOR ANY INDIRECT, SPECIAL, PUNITIVE, INCIDENTAL OR CONSEQUENTIAL
|
|
* LOSS, DAMAGE, COST OR EXPENSE OF ANY KIND WHATSOEVER RELATED TO THE
|
|
* SOFTWARE, HOWEVER CAUSED, EVEN IF MICROCHIP HAS BEEN ADVISED OF THE
|
|
* POSSIBILITY OR THE DAMAGES ARE FORESEEABLE. TO THE FULLEST EXTENT
|
|
* ALLOWED BY LAW, MICROCHIP'S TOTAL LIABILITY ON ALL CLAIMS IN ANY WAY
|
|
* RELATED TO THIS SOFTWARE WILL NOT EXCEED THE AMOUNT OF FEES, IF ANY,
|
|
* THAT YOU HAVE PAID DIRECTLY TO MICROCHIP FOR THIS SOFTWARE.
|
|
*
|
|
* \asf_license_stop
|
|
*
|
|
*/
|
|
|
|
#ifndef _HPL_USB_H_INCLUDED
|
|
#define _HPL_USB_H_INCLUDED
|
|
|
|
#include <compiler.h>
|
|
#include <utils.h>
|
|
|
|
#ifdef __cplusplus
|
|
extern "C" {
|
|
#endif
|
|
|
|
/** \name USB Spec definitions */
|
|
/*@{*/
|
|
|
|
/** Return 8-bit unsigned USB data. */
|
|
#define USB_GET_U8(addr, offset) (((uint8_t *)(addr))[(offset)])
|
|
|
|
/** Return 16-bit unsigned USB data. */
|
|
#define USB_GET_U16(addr, offset) ((((uint8_t *)(addr))[(offset) + 0] << 0) + (((uint8_t *)(addr))[(offset) + 1] << 8))
|
|
|
|
/** Return 32-bit unsigned USB data. */
|
|
#define USB_GET_U32(addr, offset) \
|
|
((((uint8_t *)(addr))[(offset) + 0] << 0) + (((uint8_t *)(addr))[(offset) + 1] << 8) \
|
|
+ (((uint8_t *)(addr))[(offset) + 2] << 16) + (((uint8_t *)(addr))[(offset) + 3] << 32))
|
|
|
|
/** Offset of bmRequestType in USB request buffer. */
|
|
#define USB_bmRequestType_Offset 0
|
|
|
|
/** Offset of bRequest in USB request buffer. */
|
|
#define USB_bRequest_Offset 1
|
|
|
|
/** Offset of wValue in USB request buffer. */
|
|
#define USB_wValue_Offset 2
|
|
|
|
/** Offset of wIndex in USB request buffer. */
|
|
#define USB_wIndex_Offset 4
|
|
|
|
/** Offset of wLength in USB request buffer. */
|
|
#define USB_wLength_Offset 6
|
|
|
|
/** Get value of bmRequestType from USB request. */
|
|
#define USB_GET_bmRequestType(req) USB_GET_U8((req), USB_bmRequestType_Offset)
|
|
|
|
/** Get value of bRequest from USB request. */
|
|
#define USB_GET_bRequest(req) USB_GET_U8((req), USB_bRequest_Offset)
|
|
|
|
/** Get value of wValue from USB request. */
|
|
#define USB_GET_wValue(req) USB_GET_U16((req), USB_wValue_Offset)
|
|
|
|
/** Get value of wIndex from USB request. */
|
|
#define USB_GET_wIndex(req) USB_GET_U16((req), USB_wIndex_Offset)
|
|
|
|
/** Get value of wLength from USB request. */
|
|
#define USB_GET_wLength(req) USB_GET_U16((req), USB_wLength_Offset)
|
|
|
|
/** USB request IN indication of bmRequestType. */
|
|
#define USB_REQ_TYPE_IN 0x80u
|
|
|
|
/** USB endpoint number mask of bEndpointAddress. */
|
|
#define USB_EP_N_MASK 0x0Fu
|
|
|
|
/** USB endpoint direction bit of bEndpointAddress. */
|
|
#define USB_EP_DIR 0x80u
|
|
|
|
/** Get USB endpoint direction from endpoint address. */
|
|
#define USB_EP_GET_DIR(ep_addr) ((ep_addr)&USB_EP_DIR)
|
|
|
|
/** Get USB endpoint number from endpoint address. */
|
|
#define USB_EP_GET_N(ep_addr) ((ep_addr)&USB_EP_N_MASK)
|
|
|
|
/** Transfer type in EP descriptor bmAttributes: Control. */
|
|
#define USB_EP_XTYPE_CTRL 0x0
|
|
|
|
/** Transfer type in EP descriptor bmAttributes: Isochronous. */
|
|
#define USB_EP_XTYPE_ISOCH 0x1
|
|
|
|
/** Transfer type in EP descriptor bmAttributes: Bulk. */
|
|
#define USB_EP_XTYPE_BULK 0x2
|
|
|
|
/** Transfer type in EP descriptor bmAttributes: Interrupt. */
|
|
#define USB_EP_XTYPE_INTERRUPT 0x3
|
|
|
|
/** Transfer type mask in EP descriptor bmAttributes. */
|
|
#define USB_EP_XTYPE_MASK 0x3u
|
|
|
|
/*@}*/
|
|
|
|
/** \name USB status codes
|
|
*@{
|
|
*/
|
|
/** USB operation is done successfully. */
|
|
#define USB_OK 0
|
|
/** USB (endpoint) is busy. */
|
|
#define USB_BUSY 1
|
|
/** USB (endpoint) is halted. */
|
|
#define USB_HALTED 2
|
|
|
|
/** General error. */
|
|
#define USB_ERROR 0x10
|
|
/** Operation is denied by hardware (e.g., syncing). */
|
|
#define USB_ERR_DENIED 0x11
|
|
/** Input parameter error. */
|
|
#define USB_ERR_PARAM 0x12
|
|
/** Functionality is not supported (e.g., initialize endpoint without cache to be control). */
|
|
#define USB_ERR_FUNC 0x13
|
|
/** Re-initialize, re-enable ... */
|
|
#define USB_ERR_REDO 0x14
|
|
/** Not enough resource (memory, endpoints ...). */
|
|
#define USB_ERR_ALLOC_FAIL 0x15
|
|
/*@}*/
|
|
|
|
/** USB speed. */
|
|
enum usb_speed {
|
|
/** USB Low Speed. */
|
|
USB_SPEED_LS,
|
|
/** USB Full Speed. */
|
|
USB_SPEED_FS,
|
|
/** USB High Speed. */
|
|
USB_SPEED_HS,
|
|
/** USB Super Speed. */
|
|
USB_SPEED_SS
|
|
};
|
|
|
|
/** USB transaction type. */
|
|
enum usb_trans_type {
|
|
/** USB SETUP transaction. */
|
|
USB_TRANS_SETUP,
|
|
/** USB IN transaction. */
|
|
USB_TRANS_IN,
|
|
/** USB OUT transaction. */
|
|
USB_TRANS_OUT
|
|
};
|
|
|
|
/** USB events that generates the device callbacks. */
|
|
enum usb_event {
|
|
/** USB VBus changed, with parameter as present/not present. */
|
|
USB_EV_VBUS,
|
|
/** USB RESET detected on bus. */
|
|
USB_EV_RESET,
|
|
/** USB wakeup. */
|
|
USB_EV_WAKEUP,
|
|
/** USB LPM suspend, with parameter as \ref usb_lpm_attributes. */
|
|
USB_EV_LPM_SUSPEND,
|
|
/** USB suspend. */
|
|
USB_EV_SUSPEND,
|
|
/** USB error, with parameter as error code. */
|
|
USB_EV_ERROR,
|
|
/** Number of USB event types. */
|
|
USB_EV_N
|
|
};
|
|
|
|
/** Control action for USB device endpoint stall. */
|
|
enum usb_ep_stall_ctrl {
|
|
/** Clear stall of the endpoint. */
|
|
USB_EP_STALL_CLR,
|
|
/** Stall the endpoint. */
|
|
USB_EP_STALL_SET,
|
|
/** Return the stall status. */
|
|
USB_EP_STALL_GET
|
|
};
|
|
|
|
/** Control action for USB device endpoint halt. */
|
|
enum usb_ep_halt_ctrl {
|
|
/** Clear halt of the endpoint. */
|
|
USB_EP_HALT_CLR = USB_EP_STALL_CLR,
|
|
/** Stall the endpoint. */
|
|
USB_EP_HALT_SET = USB_EP_STALL_SET,
|
|
/** Return the halt status. */
|
|
USB_EP_HALT_GET = USB_EP_STALL_GET
|
|
};
|
|
|
|
/** USB transactions status codes. */
|
|
enum usb_trans_code {
|
|
/** TX or RX has been done without error. */
|
|
USB_TRANS_DONE,
|
|
/** The endpoint is stalled. */
|
|
USB_TRANS_STALL,
|
|
/** The endpoint transactions are aborted (cancel, control setup/status). */
|
|
USB_TRANS_ABORT,
|
|
/** The endpoint transactions are aborted by reset/disable. */
|
|
USB_TRANS_RESET,
|
|
/** Error is reported on the endpoint. */
|
|
USB_TRANS_ERROR
|
|
};
|
|
|
|
/** Transfer status codes. */
|
|
enum usb_xfer_code {
|
|
/** Transfer is done without error, for ctrl it means status packet done. */
|
|
USB_XFER_DONE,
|
|
/** For control transfer only, data stage is done without error. */
|
|
USB_XFER_DATA,
|
|
/** Endpoint stall is set. */
|
|
USB_XFER_HALT,
|
|
/** Endpoint stall is cleared. */
|
|
USB_XFER_UNHALT,
|
|
/** Transfer is aborted. */
|
|
USB_XFER_ABORT,
|
|
/** Transfer is aborted because endpoint reset/disable. */
|
|
USB_XFER_RESET,
|
|
/** There was an error. */
|
|
USB_XFER_ERROR
|
|
};
|
|
|
|
/** USB endpoint errors. */
|
|
enum usb_ep_error {
|
|
/** No error. */
|
|
USB_EP_NO_ERROR,
|
|
/** CRC error. */
|
|
USB_EP_ERR_CRC,
|
|
/** Endpoint transfer overflow. */
|
|
USB_EP_ERR_OVERFLOW,
|
|
/** Other endpoint errors. */
|
|
USB_EP_ERR_GENERAL
|
|
};
|
|
|
|
/** Endpoint transfer state. */
|
|
enum usb_ep_state {
|
|
/** Endpoint is disabled. */
|
|
USB_EP_S_DISABLED,
|
|
/** Endpoint is not busy. */
|
|
USB_EP_S_IDLE,
|
|
/** Control transfer only, endpoint is transferring setup packet. */
|
|
USB_EP_S_X_SETUP,
|
|
/** Endpoint is transferring data. */
|
|
USB_EP_S_X_DATA,
|
|
/** Control transfer only, endpoint is in status stage. */
|
|
USB_EP_S_X_STATUS,
|
|
/** Endpoint is halted. */
|
|
USB_EP_S_HALTED,
|
|
/** Endpoint error. */
|
|
USB_EP_S_ERROR
|
|
};
|
|
|
|
#ifdef __cplusplus
|
|
}
|
|
#endif
|
|
|
|
#endif /* _HPL_USB_H_INCLUDED */
|